Epson XP-452 Series User Manual

E-8
Message:
Incorrect IP address is assigned to the printer. Conrm IP address setup of the network device (hub, router, or
access point). Contact your network administrator for assistance.
Solutions:
❏ Enable DHCP on the access point if the printer’s Obtain IP Address setting is set to Auto.
❏ If the printer’s Obtain IP Address setting is set to Manual, the IP address you manually set is invalid due to out
of range (for example: 0.0.0.0). Set a valid IP address from the printer’s control panel or by using Web Cong.
E-9
Message:
Conrm the connection and network setup of the PC or other device. Connection using the EpsonNet Setup is
available. Contact your network administrator for assistance.
Solutions:
Check the following.
❏ Devices are turned on.
❏ You can access the Internet and other computers or network devices on the same network from the devices you
want to connect to the printer.
If still does not connect your printer and network devices aer conrming the above, turn o the access point.
Wait for about 10 seconds, and then turn it on. en reset your network settings by downloading and running the
installer from the following website.
http://epson.sn > Setup
E-10
Message:
Conrm
IP address, subnet mask, and default gateway setup. Connection using the EpsonNet Setup is available.
Contact your network administrator for assistance.
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ Network addresses (IP address, subnet mask, and default gateway) are correct if you have set the printer's
Obtain IP Address to Manual.
Reset the network address if they are incorrect. You can check the IP address, subnet mask, and default gateway
from the Network Status part on the network connection report.
If DHCP is enabled, change the printer’s Obtain IP Address setting to Auto. If you want to set the IP address
manually, check the printer's IP address from the Network Status part on the network connection report, and then
select Manual on the network settings screen. Set the subnet mask to [255.255.255.0].
User's Guide
Network Settings
31

Epson XP-452 Series Specifications

General

Print Technology	Inkjet
Maximum Print Resolution	5760 x 1440 dpi
Print Speed (Color)	15 ppm
Scanner Type	Flatbed
Maximum Scan Resolution	1200 x 2400 dpi
Functions	Print, Scan, Copy
Paper Tray Capacity	100 sheets
Weight	4.3 kg
Connectivity	Wi-Fi, USB
Paper Sizes Supported	A4, A5, A6, B5, Letter, Legal
Display	LCD
Ink Cartridges	Black, Cyan, Magenta, Yellow
Dimensions (W x D x H)	390 x 300 x 146 mm