- 12 -
levelling feet of the ergoselect ergometer
Caution
• Equipment Damage •
Avoid strong vibrations of the ergoselect during transport.
transPort
For short distances, the ergoselect can be lifted at the
saddle and rolled away on its castors.
To cover greater distances, however, we recommend the
following method:
• Disconnect the power cord from the wall outlet.
• Rotate the handlebar towards the front.
Tighten the clamping lever.
• Stand in front of the ergoselect, grasp the handlebar
and tilt the ergoselect towards you until it is standing
on the castors only and is balanced.
• It is now possible to transport the ergoselect.
• When you have reached the new location, lower the
ergoselect very carefully to avoid damage.
setuP
Place the ergoselect on a level oor.
The ergoselect must be set up in a secure and stable posi‑
tion ‑ the two levelling feet at the back make for easy
adjustment to uneven oor surfaces. Extend the foot
concerned until the ergoselect no longer wobbles.
In case of delicate ooring, it is recommended to place
a mat under the ergometer to protect the ooring from
damage by the feet.
transporting the ergoselect
To Next Page
Loading...
Need help?
General
