ergoline ergoselect 100 User Manual

- 26 -
 
+5W  -5W+5W  -5W
PCMode
Ergometry
Manual
Settings
 Select
main menu
manual
Use the softkeys on the right and left (↑↓) to position the
bar cursor on MANUAL and conrm the selection with
SELECT.
In this operating mode the user controls the entire exercise
test by selecting the loads, stage times and by initiating
blood pressure measurements.
The exercise test is started with the "Start" key, afterwards
the load can be set and changed with the +5 W and ‑5 W
keys (in increments of +/‑1 W up to +/‑25 W, as cong‑
ured).
Blood pressure measurements an be initiated with .
terminatinG an exerCise test
The exercise test can be terminated manually at any time
with the END key located in the middle.
The load will immediately drop to 0 watt.
There is no recovery phase in the manual mode.
 Start
initial screen of a manual exercise test
screen display during the test
+5W  -5W
 End

ergoline ergoselect 100 Specifications

General

Brand	ergoline
Model	ergoselect 100
Category	Exercise Bike
Language	English