ergoline ergoselect 100 User Manual

- 27 -
 
 
 
 
settinGs with Control terminal P
Some of the device settings are congurable to meet spe‑
cic requirements. The settings will be saved and remain
stored even when the ergometer is switched o.
Use the softkeys on the right and left (↑↓) to position the
bar cursor on SETTINGS and conrm the selection with
SELECT.
The conguration menu displays.
When all changes have been made, you can exit the con‑
guration menu with the key.
Use the softkeys on the right and left (↑↓) to position the
bar cursor on the parameter to change and conrm the
selection with SELECT.
Default moDe
In this menu you choose the default mode activated when
the ergometer is turned on. When rst turned on, the
ergometer will display this menu.
Use the softkeys on the right and left (↑↓) to position the
bar cursor on your preferred default mode and save the
selection with SELECT.
ProtoCols
Protocols 6 ‑ 15 are user‑programmable (protocols 1 ‑ 5
are xed, see Appendix for protocol parameter details).
Standard values for the following parameters can be
entered:
‑ initial load
‑ stage time
‑ load increment (load increase with each stage)
Use the softkeys on the right and left (↑↓) to position
the bar cursor on the protocol to change (No. 6 ‑ 15) and
conrm the selection with SELECT.
PCMode
Ergometry
Manual
Settings
 Select
main menu
configuration menu
Settings
DefaultMode
Protocols
Contrast
LoadChange
Language
 Select
selecting the default mode
DefaultMode
Menu
PCMode
Ergometry
Manual
 Select
selecting the exercise test protocol to edit
Protocols
1.WHO
2.BAL
3.Hollmann
4.STD.France
5.Standard
 Select

ergoline ergoselect 100 Specifications

General

Brand	ergoline
Model	ergoselect 100
Category	Exercise Bike
Language	English