ergoline ergoselect 100 User Manual

- 41 -
↑
↓
↑
↓
settinGs for Control terminals K
Some of the device settings are congurable to meet spe‑
cic requirements. The settings will be saved and remain
stored even when the ergometer is switched o.
Select SETTINGS to display the conguration menu.
When all changes have been made, you can exit the con‑
guration menu with the key.
Use the softkeys (↑↓) to position the bar cursor on the pa‑
rameter to change and conrm the selection with SELECT.
Default moDe
In this menu you choose the default mode activated when
the ergometer is turned on. When rst turned on, the
ergometer will display this menu.
Use the softkeys (↑↓) to position the bar cursor on your
preferred default mode and save the selection with SELECT.
ProtoCols
Protocols 6 ‑ 15 are user‑programmable (protocols 1 ‑ 5
are xed, see Appendix for protocol parameter details).
Standard values for the following parameters can be
entered:
‑ initial load
‑ stage time
‑ load increment (load increase with each stage)
‑ NIBP lead time (blood pressure measurement)
‑ recovery load
‑ recovery time
Use the softkeys (↑↓) to position the bar cursor on the
protocol to change (No. 6 ‑ 15) and conrm the selection
with SELECT.
selecting the exercise test protocol to edit
configuration menu
Settings
Default Mode
Protocols
Contrast
Load Change
Language
Beep
Software Version
Date/Time
Training
Select
EKG Type
Choosefunction
Protocols
1. WHO
2. BAL
3. Hollmann
4. STD. France
5. Standard
6. 25W / 2min / 25W
7. 25W / 2min / 25W
8. 25W / 2min / 25W
9. 25W / 2min / 25W 
Select
10. 25W / 2min / 25W
Choosefunction

ergoline ergoselect 100 Specifications

General

Brand	ergoline
Model	ergoselect 100
Category	Exercise Bike
Language	English