ergoline ergoselect 100 - Page 40

- 40 -
↑
↓
The name and the weight stored on the card are displayed.
You can use the arrow keys to enter the current weight.
Press the "Next" key and the initial screen will display.
You can initiate the displayed training protocol or select
another protocol from the chip card.
The chip card training session proceeds in the same way as
the exercise tests stored in the ergometer.
terminatinG the traininG session
After termination of the training session (automatic ter‑
mination when the programmed recovery phase has been
completed, or manual termination) the test subject can
state how the test was perceived (BORG scale).
Subsequently all training data are written to the chip card
and are then available for analysis with a special program
(e.g. opticare basic).
entering the weight
TrainingChipcard
Sumner
David
Weight+
93kg
Weight-
Next
Makesettings
entering the borg value
TrainingChipcard
Stress
very very heavy
very heavy
heavy
a little stronger
easy
very easy
very very easy
 OK
writing to the chip card
TrainingChipcard
Sumner
David
Trainingnished!
Writingcard!