- 39 -
aDjustments DurinG the traininG session
Press the key to display the conguration menu.
This is what you can do during the training session
• end the training session and advance to the recovery
phase,
• directly terminate the training session,
• change the display mode (see "PC Mode").
traininG with ChiP CarD
As an alternative to the training protocols saved in the
ergometer, it is possible to load training protocols from the
chip card.
The training protocols are saved to the chip card by means
of a PC program ("ergoline opticare professional" or "ergo‑
line opticare basic").
Upon completion of the training session, the entire proce‑
dure (incl. load and heart rate waveforms) is saved to the
chip card and can be reviewed and analyzed at the PC.
startinG the ChiP CarD traininG session
Select the "Training" mode and insert the chip card into
the card reader (on the side of the control terminal).
The ergometer switches to the chip card mode and reads
the data stored on the card.
configuration menu
Recoveryphase
End
Previous Display
Trainingrunning
reading the chip card data
TrainingChipcard
Readingcard!
To Next Page
Loading...
Need help?
General
