ergoline ergoselect 100 - CONTROL TERMINAL K; Turning the System On (Terminal K)

- 32 -
ergoline
GmbH
ergoline
GmbH
Control terminal K
turninG the system on
You turn the ergometer on by pressing the power switch ‑
the green indicator in the switch lights up.
The ergometer runs a self‑test. Subsequently, the main
menu displays.
Note
• Instruct the patient not to pedal while the ergometer is
being turned on and during the self-test.
• Apply the blood pressure cu to the patient AFTER the
ergometer has been turned on and the self-test been
completed.
• The device may be congured to default to one of the
operating modes.
If this option is selected, the initial screen of the selected
operating mode (e.g. Ergometry) will be displayed instead
of the main menu.
With the
key, you can display the main menu.
• If an error message (e.g. E:01) appears immediately after
the self-test, please refer to the "Troubleshooting" section
for advice.
self-test screen
 Selftestrunning
main menu
The ergometer software is controlled with 8 keys:
With this key you display the main menu or
return to the previous menu level.
With this key you initiate a blood pressure mea‑
surement. A measurement in progress can be aborted with
the same key.
The functions of these six softkeys
change with the displayed menu ‑ the
key label describing the function is
shown on the display.
Keypad K
ExerciseTest PCMode
Training Manual
Test Settings