ergoline ergoselect 100 - Setting Load Change Increments

- 28 -
 
 
 
 
Use the right and left softkeys ↑↓ to select the parameter
to edit.
When conrmed with SELECT, the corresponding value ap‑
pears in reverse video and can be changed with the arrow
keys ↑↓.
Pressing SELECT will save the new value.
All other parameters are edited in the same way.
You exit the conguration with .
Contrast
The display contrast is adjustable in the range from
0 to 100%.
loaD ChanGe
Here you determine the increments for each load change.
Depending on your choice, each key press will change the
load by +/‑ 1, 5, 10 und 20 Watts.
selecting the parameter to edit
Protocol
6.
BasicLoad  25W
StageTime  2min
LoadStage  25W
 Select
editing the parameter value
Protocol
6.
BasicLoad  25W
StageTime  2min
LoadStage  25W
 Select
adjusting the display contrast
LoadChange
+/- 1Watt
+/- 5Watt
+/- 10Watt
+/- 25Watt
 Select
Contrast

50%
 Select
selecting the increment for manual load changes