- 15 -
Connecting the ECG Cable
ergoselect ergometers can be connected to electrocardio‑
graphs and PC‑based ECG systems of most manufacturers.
Dierent connection cables are available to support dier‑
ent communication modes (digital, analog, remote start,
etc.).
The appropriate cable is plugged into the corresponding
socket on the connection panel (Port 1, USB) and secured
with the strain relief.
Hint
• connecting cables •
Only use connecting cables released by ergoline.
To use the integrated USB connector, a special driver is required
- contact ergoline.
eKg / pc connection
USB PC connection via USB (virtual COM)
PORT 1 Digital connection RS232 (remote control
by PC or ECG recorder,
To Next Page
Loading...
