ERVOR G06 - Operation and Initial Use; First Start-Up Safety and Procedure

Page 16
ERVOR (SCA) - 6, Rue Désiré Granet - Z.I. du Val d'Argent - 95100 ARGENTEUIL FRANCE
 (33) 01 34 11 50 00  (33) 01 34 11 50 10
Web : www.ervor.com - Email : info@ervor.com
Manual G06
Edition: 10/2015 - rev A
7 - USING THE COMPRESSOR FOR THE FIRST TIME
7 - A - SAFETY REMINDERS
))
))
) DO NOT START THE COMPRESSOR WHEN PEOPLE ARE WORKING ON IT.
))
))
) ONLY QUALIFIED PERSONNEL WHO ARE CONVERSANT WITH THE INSTRUCTIONS
IN THIS MANUAL SHOULD OPERATE AND/OR MAKE ADJUSTMENTS TO THE
COMPRESSOR AND ELECTRIC MOTOR.
))
))
) DO NOT ATTEMPT TO CARRY OUT MAINTENANCE OR REPAIRS WHILE THE MOTOR
IS RUNNING.
))
))
) NEVER START THE COMPRESSOR WITHOUT THE COUPLING PROTECTION
))
))
) NEVER CLOG THE AIR FILTER.
7 - B - SAFETY MEASURES
))
))
) BEFORE THE FIRST START-UP CHECK THE OIL LEVEL.
))
))
) CHECK THE SUPPLY VOLTAGE.
))
))
) THE SITE MUST BE CLEAN WITH GOOD VENTILATION.
))
))
) INSTALL COMPRESSOR ON LEVEL GROUND AWAY FROM HEAT SOURCE AND DUST.