ESAB CIGWELD CutSkill 60 - Installation; Unpacking; Lifting Options

CutSkill 60
OPERATING MANUAL
0-5574 3-1 INSTALLATION
SECTION 3:
INSTALLATION
3.01 Unpacking
1. Use the packing lists to identify and account for each item.
A. Contents List
Description Quantity
Power Source 1
CutSkill 60A Torch 1
Work Cable and Clamp (3m) 1
Shoulder Strap 1
Nitto Air Fitting Nipple, Male Plug - 1/4" 1
Wrench for Air Filter 1
Operating Manual 1
Gouging Tip 60A 1
2. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and / or ship-
ping company before proceeding with the installation.
3. Record Power Supply and Torch model and serial numbers, purchase date and vendor name, in the information
block at the front of this manual.
3.02 Lifting Options
The Power Supply includes a handle for hand lifting only. Be sure unit is lifted and transported safely and
securely.
!
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving unit.
FALLING EQUIPMENT can cause serious personal injury and can damage equipment.
HANDLE is not for mechanical lifting.
•Onlypersonsofadequatephysicalstrengthshouldlifttheunit.
•Liftunitbythehandle,usingtwohands.Donotusestrapsforlifting.
•Useoptionalcartorsimilardeviceofadequatecapacitytomoveunit.
•Placeunitonaproperskidandsecureinplacebeforetransportingwithaforkliftorothervehicle.