ESAB ES 150i - Read This First Safety Guidelines; Product and Serial Number Compatibility; Safety and Function Responsibility; Mandatory Instruction Manual Review

READ THIS FIRST
0463 714 001
- 4 -
© ESAB AB 2020
READ THIS FIRST
Maintenance and repair work must be performed by an experienced person, and electrical
work only by a trained electrician. Use only recommended replacement parts.
This service manual is intended for use by technicians with electrical/electronic training for
help in connection with fault-tracing and repair.
Use the wiring diagram as a form of index for the description of operation. The circuit boards
are divided into numbered blocks, which are described individually in more detail in the
description of operation. Component names in the wiring diagram are listed in the
component description.
Use the spare parts list as a guide to where the components are located in the equipment.
The spare parts list is published as a separate document, see the "SPARE PARTS AND
ACCESSORIES" chapter in this manual.
This manual contains details of design changes that have been made up to and including
January 2020.
Product Valid from serial
number
The manual is valid for:
ES 150i, Europe HA017-xxxx-xxxx
ES 180i, Europe HA018-xxxx-xxxx
ES 180i Pro, Europe HA019-xxxx-xxxx
ES 200i Pro, Europe HA020-xxxx-xxxx
ES 200i Pro, Middle East HA020-xxxx-xxxx
ES 200i Pro, India HA020-xxxx-xxxx
ES 200i Pro, SEA HA020-xxxx-xxxx
ET 180iP, Europe HA026-xxxx-xxxx
ET 200iP, India HA027-xxxx-xxxx
ET 200iP Pro, Europe HA027-xxxx-xxxx
ET 200iP Pro, Middle East HA027-xxxx-xxxx
ET 200iP Pro, India HA027-xxxx-xxxx
ET 200iP Pro, South East Asia HA027-xxxx-xxxx
NOTE!
The unit is tested by ESAB in a general set-up. The responsibility for safety and
function, of the specific set-up, lies with the integrator.
The "ES 150i", "ES 180i", "ES 180i Pro", "ES 200i Pro", "ET 180iP", "ET 200iP" and
"ET200iPPro" are designed and tested in accordance with the standards stated in the
instruction manual. On completion of service or repair work, it is the responsibility of the
person(s) performing the work to ensure that the product still complies with the requirements
of the involved standards.
CAUTION!
Read and understand the instruction manual before
installing or operating.