5 OPERATION
0463 930 001
- 17 -
© ESAB AB 2023
4) Lock the wire spool onto the brake hub, by tightening the brake hub nut.
5) Thread the wire through the feeder mechanism.
NOTE!
Replace the brake hub nut and the brake hub sleeve if they are worn out and do not lock
properly.
6) Close and lock the left door of the wire feeder.
5.8 Changing feed rollers
When changing to a different type of wire, the feed rollers should be changed to match the new type of
wire. For information about correct feed roller depending on wire diameter and type, see the WEAR
PARTS appendix.
1) Open the left door of the wire feeder.
2) Unlock the feed rollers to be exchanged, by rotating the roller quick lock (A) for each roller.
3) Relieve the pressure on the feed rollers, by folding the tensioner units (B) down and thereby
releasing the swing arms (C).
4) Remove the feed rollers and install the correct ones (according to the WEAR PARTS appendix).
5) Reapply the pressure on the feed rollers, by pushing the swing arms (C) down and secure them
using the tensioner units (B).
6) Lock the rollers by rotating the roller quick locks (A).
7) Close and lock the left door of the wire feeder.
5.9 Changing the wire guides
When changing to a different type of wire, the wire guides may have to be changed to match the new
type of wire. For information about the correct wire guides depending on wire diameter and type, see
the WEAR PARTS appendix.
To Next Page
Loading...
Need help?
General
