Escea EF5000 - F6 Operating the Appliance; F7 Normal Operating Sounds and Smells

B
ACDEFGSERVICE
25
F6 Operating the Appliance
The EF5000 is operated by an ON/OFF switch located on the right hand outer edge of the fascia.
Before operating the fire, ensure the power transformer is plugged into the mains wall socket and
turned on; also ensure that the supply is turned on.
ON/OFF Power Switch
To turn the fire on, push the ON/OFF rocker switch to the open position. The ignition unit will start
sparking and the pilot and burners will ignite almost immediately.
If there is no gas, the ignition unit will attempt to light up to three times before
shutting down.
To turn o the fire, flick the ON/OFF rocker switch to the o position. This will
shut down the gas flow to the pilot flame and both burners.
Please ensure that the gas supply is also turned o. As an extra safety, also turn
o the main power supply at the house.
For further operation instructions please refer to the User Guide.
F7 Normal Operating Sounds and Smells
Sounds
It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to
the fact that various types of materials are used within your appliance. Listed below are some examples.
These are all normal operating sounds and should not be considered as defects in your appliance.
Gas Control Valve
As the gas control valves turn ON and OFF, a dull clicking sound may be audible. This is the normal
operation of a valve. When the fire is switched o after being run for a while, there may be popping
and fluttering noises as the residual gas in the burners burns away. These are normal and are no cause
for concern.
Unit Body/Firebox
Dierent types and thicknesses of steel will expand and contract at dierent rates resulting in some
“cracking” and “ticking” sounds being heard throughout the heating and cool down processes.