28
S
Service Manual
IMPORTANT:
• This appliance must be serviced every 12 months.
• Any service operation should be carried out only by a suitably qualified and trained
person.
• Gas and electricity supply MUST be isolated before any service operation is carried
out on this appliance.
• This manual should be left with the appliance.
• Only use Escea approved spare parts.
• Spare parts are available from an Escea Distributor or Retailer
• DO NOT MODIFY THIS APPLIANCE.
S1 Annual Service Procedure
□ Isolate power and gas supply to fire.
□ Remove fuel bed and brush o any soot.
□ Clean electrodes and pilot of any carbon build up and ensure correct gaps
between electrodes and pilot.
□ Remove burners and blow compressed air through the burner ports.
□ Remove jets and clean injector hole with solvent.
□ Vacuum any dust from the underside of the fire box around the valve.
□ Test all joints for gas tightness.
□ Reassemble heater and check that operating pressure is correct.
□ Trial heater with several start/stop cycles.
To access the product data plate, remove the fascia. Product information is located inside the fire on
the bottom right hand side beside the engine.
S2 Maintenance and Cleaning
The unit must be cold before starting any form of maintenance or cleaning. To remove the glass and
stones in the front stone tray, reverse the steps in section F1 “Assembly of the Stone Cartridge” on
page 22 and F3 “Placement of Ceramic Stones” on page 23. The glass can be cleaned using
any standard window cleaner and the quartz river stones can be washed using soapy water.
Periodically, the pilot and burners should be checked visually for carbon and soot build-up, consistent
flame, and clean burning.
Cleaning of the burners and ceramic stones can be carried out using a brush and a dry cloth. This
should be done at least annually to remove carbon or soot buildup.
To Next Page
Loading...
