31
4. The cleaner will leave a very fine film over the fascia, ensure this film is distributed evenly.
5. If the cleaner is applied too heavily and is quite visible, you can remove the excess by gently wiping
dry with a microfibre cloth. Ensure your strokes still follow the direction of the grain or brush finish.
6. Ensure that no film is applied to the glass of your Escea Gas Fireplace. If applied accidentally, wipe
o with an absorbent microfibre cloth.
For Powder Coated Fascias:
1. Ensure that the gas fireplace is o and that the fascia is cold to the touch.
2. Gently clean the fascia with a cloth and warm soapy water.
3. Wipe o with an absorbent microfibre cloth.
S6 Checking Operating Pressure
See section E6 “Checking the Gas Operating Pressure” on page 20 of this manual.
S7 Replacing the Burners
Remove the fascia and fuelbed by reversing the steps in sections F2 “Fitting the Fascia” on page
22 and F3 “Placement of Ceramic Stones” on page 23. Remove the burners and replace them
with the spare parts provided.
S8 Serial Number
The data label containing all technical information such as manufacture date, serial number, gas type,
jet size, and other information can be found below the firebox in the lower right hand side of the fire.
To access this, the fascia must be removed.
S9 Removing the Control Tray
1. Isolate power and gas to the fire. Lift the fascia and hang it in the second slot. Unplug the fascia leads
and fully remove the fascia from the firebox by lifting up and outwards.
2. Remove all of the fuelbed media and the two screws holding the burner in place.
3. Remove the two screws holding the stone tray in place and lift it out.
To Next Page
Loading...
