30
S4 Operation Chart
S5 Cleaning the Fuelbed and Fascia
ALWAYS USE GLOVES WHEN HANDLING THE FASCIA.
Use a soft brush to clean the fuel bed media, being careful to replace it according to the instructions in
section F3 “Placement of Ceramic Stones” on page 23.
If soot build up on the fuelbed becomes excessive or regular then one of the following actions may be
required:
• Reset the gas pressure - pressure may be too high;
• Reposition the fuelbed;
• Clear any blockage from primary aeration port of burners.
The outside of an Escea Fascia must only be cleaned with a soft microfibre cloth. If heavier cleaning is
required for the likes of grease or stubborn fingerprint removal we recommend the use of a dedicated
stainless steel cleaner for stainless steel fascias or warm soapy water for powder coated fascias.
NEVER RUB THE FASCIA.
For Stainless Steel Fascias:
1. Ensure that the gas fireplace is o and that the fascia is cold to the touch.
2. Using a stainless steel cleaner and a clean cloth, apply a small amount of cleaner to the cloth and
wipe the fascia with even, straight strokes.
3. Make sure your strokes follow the direction of the grain or brush finish. Wiping across the grain can
leave small scratches.
To Next Page
Loading...
