Page 49
SENDING SMS THROUGH DB-9
3G.next allows to:
- send received SMS text messages to devices wired in the DB-9
connector (in RS-232 standard);
- send SMS text messages from devices wired in the DB-9 connector (in
RS-232 or CAN-bus standard).
DB-9 settings
Communication standard
It allows to define the communication standard utilized via
DB-9 connector.
Default: RS-232.
(standard) (confirm)
Lift the handset and dial: **12*.
Enter:
0 communication disabled;
1 RS-232;
3 CAN-bus.
Dial # to confirm.
After the confirmation tone carry on with the following
programming of the communication parameters.
Note: for CAN-bus communication please refer to
corresponding documentation.
Serial communication settings
It allows to set the parameters required for serial communication.
Default: 115200/8/1/none.
To Next Page