Page 51
READING “AUTOMATIC CONVERTER”
NUMBERS
It is possible to check remotely, via SMS, the preset numbers and the
stored selected numbers (see chapter “Programming via SMS” for the
use of SMS).
Reading preset numbers
The programming code to be contained in the message text must be the
following :
where:
XXX: programming password
X: preset number location
Reading previously selected numbers
The programming code to be contained in the message text must be the
following:
dove:
XXX: programming password
X: selected number location
An answer message will be returned to user or the system administrator
who sent out the SMS.
Example :
an SMS has been sent out to ascertain the preset number stored
at location 1 (071123456).
Outgoing message text:
ET-IG5*0#26*0*1R#
Answer message text:
ET?IG5*0#26*0*1R071123456#
To Next Page
Loading...
Need help?
General
