Page 52
READING THE RELAY STATUS
It is possible to check remotely, via SMS, the relay status (see chapter
“Programming via SMS” for the use of SMS).
The programming code to be entered in the text message must be as
follows:
An answer message will be returned to user or the system administrator
who sent out the SMS.
Text included in the return message if relay is OFF:
920
Text included in the return message if relay is ON:
921.
ACTIVATION RELAY
Allows you to activate or deactivate the relay available in the R2R and
3G versions when it is not used to signal the external power supply and/or
GSM/UMTS network failure.
(value) (confirm)
Lift the handset and dial: **92*.
Enter:
0 to deactivate the relay (bistable only);
1 to activate the relay.
Dial # to confirm.
After the confirmation tone hang up.
To Next Page
Loading...
Need help?
General
