1
2
1. Storage
1
. Points to check for long-term storage
Turn the power switch OFF
Remove the power cord from the outlet
Put the dust proof cover on the main unit
2
. Notes on storage environment
Avoid storage under the following conditions:
Dusty place
Where water may get on the device
High-temperature and humidity
Where sunlight directly contacts
Unstable and high place
If an error message other than shown above is displayed or an error message is still displayed even
after performing the procedure above, turn off the power, disconnect the power cord and contact
your local distributor.
2. Maintenance
a
. Replacement of marking pen
The marking pen is the consumable item.
Replace it if the imprint becomes thin or the pen tip is worn.
Remove the marking pen by pressing and rotating it 90 degrees as shown below.
Insert the new pen back to the initial position as shown below.
USER MANUAL > STORAGE AND MAINTENANCE
63 ALM800 - Auto lensmeter > V1 - 05-2020
To Next Page
Loading...
Need help?
General
