7
6
5
4
3
2
Proceed to lens assembly and check that edging was correctly configured.
If your job is perfect, proceed with the machining of your second lens.
> All of the selected finishing options and modifications made are kept.
If the lens requires adjustment, do a retouch on the edged lens to obtain optimal results.
Indicate the size reduction to be applied to the lens you want to retouch.
Insert the lens in the posiblock holder.
To close the clamp shafts manually, press and hold .
Close the door.
Press .
Select the second lens to be edged directly on screen, on the left or right of the work area.
Depending on your job:>
The chosen finish and the modifications made during the edging cycle are automatically selected.>
For a customized finish, the customized finish screen is displayed.>
In all the other cases, the automatic tightening of the lens and the retouch start consecutively.>
The edging screen for the second lens is displayed.>
All finishes chosen and the modifications made are kept. The retouch done on the first lens is automatically saved for the
edging of the second lens.
>
To Next Page
Loading...
