3.
4.
5.
6.
7.
8.
9.
10.
11.
1.
2.
Tracing of a high-base frame
: Tracing using the pattern holder
Traced frame materials
Metal frame: high-precision tracing, with feeling of the groove
Plastic frame
Optical tracings carried out
Optical tracing
Tracing of a pattern
Tracing of a recut /demo lens
Tracing table tests and calibrations
Next page / Previous page
Centering operations
Blocking operations
Calibrations and inspections of the centering calibration
Reset
You can reset a partial counter to zero:
Select the cycle counter to reset to zero.
Press to reset it to zero.
Statistics if the Tess tracer is connected but not turned on
In the case of a Tess tracer that’s connected but not turned on, the values are overridden by “X”, like below.
To Next Page
Loading...
