4
3
2
1
4
3
2
1
4
3
2
1
b. Groove detection
By default, feeler insertion is configured in the centre of the frame thickness: .
Enter the desired job number, between 1 and 200 (beyond your job will not be memorized).
Press to confirm.
After the validation of the job number or current job, press on to choose the adapted feeler insertion.
While carrying out:
1 support, choose low insertion: arrow aiming downwards .
2 supports, choose high insertion: arrow aiming upwards .
3 supports, you return to the main screen .
Once the insertion is configured, press on ( ) of the tracer to launch tracing.
The job number is displayed.>
To Next Page
Loading...
Need help?
General
