5
4
3
2
1
5
4
3
2
1
5
4
3
2
1
b. Configuration of parameters (optional step)
Press simultaneously on and “1”.
Press on “6”.
Press on to enter the menu.
Press on “2”, the, Press on to access the configuration of default settings:
Serial link
Speed Flow control
INSTRUCTIONS FOR
USE
PC Port 19200 Inspection Opsys configuration
Edger port 19200 Inspection Configuration Delta T
Any modification of this configuration could harm the proper performance of the instruments. We advise that you
modify the configuration of this menu only if your configuration is not compatible with the configuration suggested by
fault and with help from your technician.
Press on “2”, the, press on to configure the data of menu “2: Settings.”
PC Port
Edger port
IP
The display indicates:>
The display indicates:>
The display indicates:>
Three choices are then possible:>
To Next Page
Loading...
Need help?
General
