8
7
6
5
4
3
2
1
3
2
1
7
Remove the USB key.
b. Software update
From the computer
Insert the Essilor USB key into the computer's USB port.
Double-click on the device.
Copy the file into format” “, which was already sent to you on the root of the USB key..tar .gz
From the tracer
Power up the tracer.
After the initialization phase, insert the Essilor USB key in the external USB port of the tracer.
Press simultaneously on and “1”.
Select by pressing on “4”, then press on .
Press on “2”, then press on to transfer the information from the USB key to the tracer.
Select by pressing on “2”, then press on .
Press on to confirm or on to cancel.
Remove the USB key, then press on .
For more information, consult the section error codes & barcodes > error codes. (p.65)
The key appears in the list of devices on your computer.>
Once the file is copied, remove the USB key.>
The display indicates:>
The display indicates:>
The display indicates:>
The display indicates:>
At the end of the update, the display indicates:>
The tracer turns off then restarts at the end of approximately 5 seconds.>
The tracer is put in queued job position.>
To Next Page
Loading...
Need help?
General
