Etatron eSelect B2 - The Display in the Various Operation Modes (Ph - Rx - Cl); Programming Procedure; Simple Menu Mode

14
MENU SETUP
MENU MODE SIMPLE
YEAR 2013
MONTH 5
DAY 15
HOUR 4
MINUTE 52
2013/05/15 04:52 WEDNESDAY T=25
METER 2: STANDBY
2013/05/15 04:52 WEDNESDAY T=25
METER 3: ALARM: MAX
7.2. THE DISPLAY IN THE VARIOUS OPERATION MODES (PH – RX – CL)
When the instrument is switched on, the display shows the measurement value and the type of
measurement.
eSelect B2 main screen
eSelect B3 main screen
7.3. PROGRAMMING PROCEDURE
When installing the controller for the first time, the user must configure it depending on the intended type of
measurement or control.
The first action for the user to carry out is setting the operation modes for every measurement outlet: METER
1 and METER 2 for B2 controller, and METER 1, METER 2 and METER 3 for B3 controller.
When setting the instrument, it is advisable to follow the programming procedure outlined below. Conversely, if
only a single parameter must be changed, it is advisable to go directly to the menu comprising the concerned
function, and perform the necessary changes or settings.
Please note there are two different MENU MODE: SIMPLE and EXPERT and they allow to change different
parameters. EXPERT MENU allow to change all parameters but it is recommended to modify its parameters
from qualified personnel.
7.3.1. SIMPLE MENU MODE
It permits to set the following parameters:
620mV
SET1:OFF mA1:4.0
SET1:OFF mA2:4.0
7.47 pH
SET1:ON mA1:12.4
SET1:OFF mA2:12.4
620mV
SET1:OFF mA1:10.4
SET1:ON mA2:10.4
7.47 pH
SET1:ON mA1:12.4
SET1:OFF mA2:12.4
11.63 Cl ppm
SET1:OFF mA1:10.4
SET1:ON mA2:10.4