Etatron eSelect B2 - Year, Month, Day, Hour, Minute; Set Password; Set Defaults

20
MENU SETUP 1/2
MENU MODE EXPERT
METER TYPE pH
T SENSOR NONE
SET TEMPERATURE 25.0
CALIBRATION MENU TIMEOUT 05:00
DELAY AT STARTUP 00:05
AUX OUTPUT MODE CLEANING
CYCLE TIME 01:00
WEEKDAYS 1 MO TU WE.-- -- SA SU
START TIME 1 02:00
7.4.8. YEAR, MONTH, DAY, HOUR, MINUTE
Starting from the MENU SETUP screen, enter in YEAR or MONTH or DAY or HOUR or MINUTE by pressing +
key or – key. For each of these parameters press press OK key and set the value on right columm.
7.4.9. SET PASSWORD
As soon as the measurement is selected, proceeding within the SETUP menu, the user can decide to activate
the password security and the relating 6 digits code. The password can be any number between 000000 and
999999.
To set the value, for any digit use + or – key and move to the next digit by press ►key.
After setting all 6 digit press OK key to set the next parameter.
7.4.10. SET DEFAULTS
Starting from the MENU SETUP screen, enter in SET DEFAULT by pressing + key or – key. Than press OK key
and set one of the followings:
 NO: to don’t reset the parameters;
 MAINTAIN CALIBRATION: to reset all parameters and save only the calibration;
 RESTORE ALL: to reset all parameters.
Chose the parameter by press + or – keys.
Press
OK key to confirm the choice and set
the value for the parameter on right columm.
Modify the value for the parameter by press + or –
and ►keys. Press
OK ke
y
to confirm the choice an
d
return on left columm to set an other parameter.