Etatron eSelect B2 - Default Chapter; Table of Contents

1
Table of contents
1. GENERAL INFORMATIONS 2
2. TECHNICAL DATA 2
3. CONNECTIONS 3
3.1. eSelect B2 POWER SUPPLY CARD CONNECTIONS 3
3.2. eSelect B2 TTL OUTPUT CONNECTIONS 4
3.3. eSelect B3 POWER SUPPLY CARD CONNECTIONS 5
3.4. eSelect B3 TTL OUTPUT CONNECTIONS 6
3.5. eSelect B2/B3 PROBES CONNECTION 7
4. CONTROL PANEL DESCRIPTION 8
4.1. eSelect B2 CONTROL PANEL 8
4.2. eSelect B3 CONTROL PANEL 8
4.3. LIGHT SIGNS 9
4.4. KEYBOARD 9
5. DIMENSIONS 10
6. PARAMETER DEFAULTS 11
7. PROGRAMMING THE CONTROLLER 12
7.1. STARTING CONTROLLER OPERATION 12
7.2. THE DISPLAY IN THE VARIOUS OPERATION MODES (PH – RX – CL) 14
7.3. PROGRAMMING PROCEDURE 14
7.3.1. SIMPLE MENU MODE 14
7.3.2. EXPERT MENU MODE 15
7.4. PROGRAMMING MENU SETUP 16
7.4.1 MENU MODE 16
7.4.2. MENU METER TYPE 17
7.4.3. T SENSOR 17
7.4.4. SET TEMPERATURE 18
7.4.5. CALIBRATION MENU TIMEOUT 18
7.4.6. DELAY AT STARTUP 18
7.4.7. AUX OUTPUT MODE 19
7.4.8. YEAR, MONTH, DAY, HOUR, MINUTE 20
7.4.9. SET PASSWORD 20
7.4.10. SET DEFAULTS 20
7.5. MENU SETPOINT1, SETPOINT2 21
7.5.1. SETPOINT 22
7.5.2. MODE 22
7.5.3. HYSTERESIS 22
7.5.4. SETPOINT DELAY 22
7.5.5. TTL MODE 23
7.5.6. METER READING @4mA 23
7.5.7. METER READING @20mA 23
7.6. MENU CALIBRATION 24
7.6.1. CALIBRATE pH 7/REF.POINT 25
7.7. MENU ALARM 25
7.7.1. MENU ALARM SETTINGS 26
8. INPUT/OUTPUT CONNECTIONS 26
8.1. PROXIMITY SENSORS 26
8.2. PT100 CONNECTION 27
8.3. PRIMING OF THE PUMPS 27