Recording Your Looks For Playback 27
Record Sequence
Note: Sequences can only be used to control zones that are patched to DMX, sACN or ArtNet
addresses.
Sequences play back on sequence buttons on pages. A sequence may contain up to 99 steps with fade and
step timing.
Note: A sequence button must be available on a page before a sequence can be recorded.
Press Record and then the sequence button to begin recording a sequence.
See Edit Sequence List for information about editing an existing sequence.
Sequence recording is a mode which takes over the screen. The recording mode is shown by a red surround to
the screen.
While in the recording mode you may visit other screens to set parameters. While in those screens, a red water-
mark will be displayed showing what step you are editing.
To return to the main recording screen press Record again. You may store the step you have made and exit
immediately with Store & Exit or you may store the step and remain inside sequence recording to record fur-
ther steps with Store & New. Press Cancel to leave the recording screen without saving anything.
Store And New
The current lighting levels will be stored in the selected sequence step and recording will be remain open so
additional steps can be recorded. Use Store And Exit to close the recording mode and resume normal oper-
ation.
Store And Exit
The current lighting levels will be stored in the selected sequence step and recording will be completed. The
recording mode is then closed, and normal operation resumes. Use Store and New to keep the recording mode
open to record additional steps.
Include Options
When recording to a sequence step, you may specify which lighting zones and sets of parameters are included
in the recording by pressing the Include Options button.
Zones:
To Next Page
Loading...
