ETC Source 4WRD II - Install the Fixture

10 Source 4WRD II Installation and User Manual
Install the Fixture
Retrofit
Source Four lens tube
(not included)
Adjustable yoke
Shutters (x4) Attached power lead
Cat5 cable
strain relief
Yoke locking knob
Attach Hanging Clamp and Safety Cable
The hanging clamp attaches the fixture to the mounting pipe andallows
you to adjust the position of the mounted fixture. ETCrecommends using
1.5in schedule 40 pipe.
Tightly fasten the hanging clamp to the yoke, and then connect the safety
cable.