ETC Source 4WRD II - Clean and Maintain the Fixture; Clean the Fixture; Store the Retrofit

Source 4WRD II Installation and User Manual 19
Clean and Maintain the Fixture
Clean the Fixture
CAUTION: Do not touch or clean LED emitters with anything
other than oil-free canned air.
Fan and
fin stack
•
Use oil-free canned air to clean the
LED emitters prior to installation and
prior to storage.
•
Use oil-free canned air to clean the
fan and fin stack as part of regular
fixture maintenance.
Store the Retrofit
Store with
LEDs facing up
•
When not installed on a fixture, store the
Source 4WRDII LED in its original packaging or
in a dust-resistant plastic bag.
•
Store the Source 4WRDII LED at temperatures
of 5°C (41°F) or higher.
•
If you must store the Source 4WRDII LED below
5°C (41°F), make sure it is in an upright
position as shown. Allow it to warm to room
temperature for a minimum of one hour before
applying power.