Source 4WRD II Installation and User Manual 3
Safety
The Source 4WRD II fixture is intended for professional use only. Read the
entire manual before using this equipment.
WARNING: This fixture must be installed by a qualified
electrician in accordance with all national and local electrical
and construction codes and regulations.
WARNING: Note the following safety warnings before use:
Do not mount the fixture on or near a flammable
surface.
Do not use this fixture with a damaged power lead. If
the power lead (cord set) is damaged, it must be
replaced.
Mount and support the fixture only by the primary
suspension holes in the yoke.
Suspend the fixture from a suitable structure using only
hardware rated for the weight of the fixture.
In addition to primary suspension, attach a safety cable
to the fixture housing. An appropriate attachment point
(hole) is provided in the protruding tab on the fixture
housing.
Disconnect the unit from power and DMX and allow the
fixture to cool before removing or installing accessories,
and before all cleaning and maintenance.
Do not cover the fixture with material that is used for
thermal insulation.
To Next Page
Loading...
