4 Source 4WRD II Installation and User Manual
WARNING: Note the following safety warnings before use:
The Source 4WRD II LED is not user serviceable. Field
modification of the Source 4WRD II LED will void your
ETC warranty.
Do not use the fixture below 5°C (41°F).
Minimum storage temperature is 5°C (41°F). When the
fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature
for a minimum of 1hour before applying power.
Applying power to a cold fixture will cause damage to
the fixture and void the ETCwarranty.
Do not use this fixture if a glass lens is deeply scratched
or cracked. Damaged lenses must be replaced.
To prevent wiring damage, or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
Use the fixture in dry locations only, where humidity
does not exceed 90 percent (non-condensing). These
fixtures are not intended for outdoor use.
To Next Page
Loading...
