ETC Source 4WRD II - Line-dimming Configuration

Source 4WRD II Installation and User Manual 13
Note: When line-dimming the fixture, performance may vary
based on the control settings of the dimmer. For this reason, ETC
recommends using line-dimming for level-setting or for
architectural dimming. ETC recommends testing the Source 4WRD
II fixture on all existing dimmers that you want to use.
Use DMX mode when high-performance, live, dynamic dimming is
required.
CEM+ and CEM3
Parameter CEM+ CEM3
Curve Mod Square Mod Square
Threshold 1% 1%
Min Scale 12V 1%
Max Scale 280V 100%
Regulation OFF OFF
Preheat Disabled Disabled
DC Prevent OFF OFF
InrushPrevent OFF OFF
Scale Load 100 100
CEM Classic v2.x
Parameter Value
Mode Normal
Boost 117
CEM Classic v3.x
Parameter Value
Mode Normal
Curve Mod-Square
Scale 140
Threshold Normal