Why is my ETS STARPOWER 548 sunbed not tanning?
Several factors could be the reason why your ETS sunbed isn't tanning effectively. Ensure the sunbed is clean, following the instructions for Thorough Periodic Cleaning. Verify that the supply voltage is between 208 and 230V AC. If the lamps have been used for more than 800 hours, consider replacing them. As a last resort, replace the acrylic.
What does Er 93 mean on my ETS STARPOWER 548 timer display?
If your ETS timer display is indicating 'Er 93', it means the current sensor indicates the unit is on when it should be off. Contact servicer.
What does Er 92 mean on my ETS STARPOWER 548 timer display?
If your ETS timer display is indicating 'Er 92', it means the current sensor indicates the unit is off when it should be on. Contact servicer.
What does Er 94 mean on my ETS STARPOWER 548 timer display?
If your ETS timer display shows 'Er 94', it means the requested session time exceeds the maximum time allowed.
What does Er 91 mean on my ETS STARPOWER 548 Personal Care Products timer display?
If your ETS timer display shows 'Er 91', it indicates a timer software error. To resolve this, disconnect and then reapply power to the unit.
What to do if my ETS Personal Care Products canopy opens and closes too fast?
Your ETS sunbed utilizes a damper to control the canopy's movement speed, acting as a safety feature in case of spring lift failure. If the canopy is moving too fast, replace the damper on the back of the unit.
How to fix an ETS STARPOWER 548 canopy that won't stay up or down?
Your ETS sunbed uses a smooth gliding spring lift system to raise the canopy. This lift system may need to be adjusted slightly from time to time. See Final Adjustments for proper adjustment procedures.
Why won't the face tanners come on in my ETS Personal Care Products sunbed?
If the face tanners on your ETS sunbed aren't turning on, note that there's an initial 5-second delay. Additionally, the face tanners require cooling before they can be relit.
What to do if lamps fail to light and timer display is blank on ETS STARPOWER 548?
If the lamps aren't lighting and the timer display is blank on your ETS device, ensure the unit is properly connected to a power source. Check the AC power source itself to confirm it's working. If necessary, reset the circuit breaker or replace the fuse.
What to do if one or more lamps fail to light in my ETS STARPOWER 548 sunbed?
If you find that one or more lamps in your ETS sunbed aren't lighting up, first check that each lamp is correctly installed. If the issue persists, try switching the unlit lamp with one that is working. If the problem follows the lamp, replace the old lamp.
Details hazards of UV radiation, overexposure, skin/eye injury, and medication sensitivity.
Guidelines for tanning based on skin type and session number.
Emphasizes wearing protective eyewear to prevent severe burns or eye injury.
Instructs to disconnect power before performing any maintenance on the product.
Highlights electrical hazards, voltage limits, room temperature, and airflow requirements.
Instructions for installing the body fan power cord into the foot end endcap.
Details attaching the foot end endcap using specific screw sizes.
Instructions for attaching canopy adapter arms using gussets, bolts, and nuts.
Guides attaching the canopy arm to the hinge arm with bolts and nuts, including pin removal.
Details securing the rear lamp module using screws.
Guide to sliding the ballast tray and installing the access panel with its key.
Details connecting power cords for various components to the ballast tray.
Instructions for adjusting the canopy lift system for smooth operation.
Explains connecting the sunbed to various remote control systems.
Warns against connecting high voltage to the remote interface circuitry, which can cause damage.
Guides on manually setting the sunbed's unique 'id' before connecting to T-Max® systems.
Reiterates the warning against connecting high voltage to remote circuitry.
Important precautions before using the sunbed, including skin and hair preparation.
Highlights risks of medication interaction and operating near water.
Provides exposure time recommendations based on skin type and tanning progression.
Instructions for operating the sunbed when connected to T-Max® Manager or 1A/3A.
Reiterates the importance of wearing protective eyewear during operation.
Instructions for operating the sunbed as a stand-alone unit or with a control relay.
Instructs to disconnect power before removing protective covers for cleaning.
General| Brand | ETS |
|---|---|
| Model | STARPOWER 548 |
| Category | Personal Care Products |
| Language | English |
To Next Page
