Page 24/84
December 2019W11/W12/W13 | Operation manual
3.3.6 Braking and stopping
• To stop, step on the brake inching pedal until the wheel loader stops.
• Switch the driving switch to neutral.
• Apply the parking brake by stepping on the pedal (W11 / Figure 1) or raising the parking brake (W12 and W13 /
Figure 2).
• Additionally secure the wheel loader (see 2. "GENERAL SAFETY INSTRUCTIONS".)
3.3.7 Changing the direction of travel
Accident hazard due to improper operation of the direction switch!
Never operate the direction switch while driving. The wheel loader immediately travels in the opposite direction
without warning. Use the switch only according to instructions.
It is not necessary to press the inching pedal right down every time you change direction.
1. Decrease the driving speed until the wheel loader stops.
2. Push the direction switch in the other direction.
3. Press the gas pedal until the wheel loader starts to move.
3.3.8 Stopping and parking
Accident hazard due to people remaining in the danger zone!
Ensure that there are no persons in the wheel loader's danger zone when you stop or park the wheel loader. Park
the wheel loader only in designated areas protected against fire.
Remove the key and place the wheel chock in front of the wheels!
Secure the wheel loader when stopping and parking as described in section 7. "SECURING THE WHEEL LOADER"!
To Next Page
Loading...