Page 60/84
December 2019W11/W12/W13 | Operation manual
The engine oil filter has a bypass valve that opens if the filter is blocked.
The engine oil filter is located on the right side of the engine.
1. Open the hood
2. Place a drip tray to catch escaping oil beneath the engine oil filter.
3. Unscrew the engine oil filter.
4. Clean the sealing face on the filter body.
5. Oil the rubber seal slightly on the new engine oil filter.
6. Screw on the new engine oil filter until the rubber seal is properly seated.
7. Tighten the new engine oil filter a further half turn by hand.
8. Check the oil level and top up to the "Maximum" mark if necessary.
9. Close the hood
10. Dispose of the old engine oil filter in an environmentally compatible manner.
10.7.3 Servicing the fuel system
The fuel flows through a prefilter from the tank. The prefilter is located at:
Service the fuel system according to the inspection intervals specified in these operating instructions!
Use only clean and high quality diesel fuel! Do not use gasoline.
Risk of injury from hot and moving parts!
Never open the driver's seat with the engine running. Explosion and fire hazard! Do not smoke when handling fuel
and avoid fire or naked flames. Do not mix gasoline into the diesel fuel.
W11 W12/13
To Next Page
Loading...
