Page 59/84
December 2019W11/W12/W13 | Operation manual
If the oil level is below the "Maximum" mark, the oil must be topped up:
1. Open the oil filler neck.
2. Top up engine oil.
3. Check the oil level.
4. Top up the engine oil until the oil level is at "Maximum".
5. Close the oil filler neck.
Scalding hazard due to hot engine oil!
ENVIRONMENTAL INFORMATION
Do not harm the environment! Collect old engine oil and dispose of it in an environmentally friendly manner.
Use a sufficiently dimensioned drip tray to collect the old engine oil and use the correct oil (see 10.6 "Specifications
and fill volumes".)
1. Bring the engine to operating temperature.
2. Park the loader on a horizontal surface and apply the parking brake.
3. Lower the lifting frame completely.
4. Switch off the engine.
5. Place a sufficiently dimensioned drip tray beneath the drain plug.
6. Unscrew the drain plug and screw on the hose provided. The oil now drains from the engine.
When the engine oil has drained
1. Replace the engine oil filter (see "Replace the engine oil filter").
2. Unscrew the hose provided and screw on the drain plug.
3. Open the oil filler neck.
4. Fill engine oil into the oil filler neck until the oil level reaches the "Maximum" mark.
5. Start the engine and allow it to idle until the engine oil pressure control light goes off
6. Check the oil level and top up if necessary.
7. Close the oil filler neck.
8. Dispose of the old engine oil in an environmentally compatible manner.
Replace the engine oil filter
Scalding hazard due to hot engine oil!
To Next Page
Loading...
