Page 28/84
December 2019W11/W12/W13 | Operation manual
Use the lifting frame's operating lever (joystick).
• Press the operating lever (joystick) down: lock is switched on
Check if the lock is correctly activated.
• Pull the operating lever (joystick) upwards: lock is switched off.
3.4.6 Replacing attachments
These instructions describe exclusively the use of the following attachments:
• Lightweight goods bucket
• Pallet forks
If you want to use additional attachments for your wheel loader, observe the following points:
If other attachments are used, the operating instructions of these attachments must be observed.
The manufacturer assumes no liability for modifications made without the manufacturer's approval.
Use only attachments approved by the manufacturer for your wheel loader. The manufacturer and the distributing
dealer assume no liability when using other attachments. Avoid overloading the wheel loader. Do not use
excessively large buckets for heavy loads. Contact a specialist if new hydraulic hoses need to be installed for a new
attachment. Only qualified personnel may install hydraulic hoses. A variety of high pressure hoses are used. When
ordering for the first time, pay attention to the DIN designation on the hose or fitting. Observe the safety
instructions for replacing attachments.
1. Read the operating instructions for the relevant attachment before installation, commissioning or servicing.
2. Consult the manufacturer or a dealer and obtain approval for the conversion if the hydraulic system needs to
be converted for the use of an attachment (for example, without pressure).
3. Select the attachment to use to suit the work to be carried out.
4. Practice using the attachment before you work with it for the first time. Familiarize yourself with all functions
and operating elements before use.
To Next Page
Loading...
