Page 78/84
December 2019W11/W12/W13 | Operation manual
Recommissioning the wheel loader
• Remove the engine preservation.
• Install the battery.
• Check the tire pressures.
• Remove the preservation of the piston rods on the hydraulic rams.
• Lower the loader.
• Check the electrical system functioning.
• Unblock the articulated joint.
• Bleed the hydraulic system.
• Check steering and brake functioning.
Remove engine preservation
• Remove the sealing from the engine intake and exhaust ports.
• Remove the anticorrosive agent from the pulleys.
• Fit the fan belt.
• Drain the preservation oil and fill with engine oil.
• Start the engine.
• Check the V-belt tension after the first two hours of operation.
To Next Page
Loading...
