Evco c-pro 3 OEM - Through a Remote User Interface; Configuration; Key Description; Switching ON;OFF the Device from Epjgraph

EVCO | 06.08.2021 | AZ | 20
CAN
005_c-pro3OEM_ON-OFF_Cieco_Interfaccia_001_0.1_AZ
114CP3OEE104
c-pro 3 OEM - Hardware manual
c-pro 3 OEM blind EPJgraph
Key description
Key Instructions
ON/STAND-BY
LEFT AND RIGHT
UP AND DOWN
ENTER
Through a remote user interface
Conguration
The following procedures show an example of how to congure a programmable controller through a remote user interface
(in the example EPJgraph):
1. Disconnect the power supply of the controller and the remote user interface
2. Connect the controller to the remote user interface through the CAN CANBUS port
3. Connect the power supply of the controller and the remote user interface
Switching ON/OFF the device from EPJgraph
Progression Description
1
Connect the controller to the remote user
interface through the CAN CANBUS port
2
Touch simultaneously the LEFT and ENTER keys
to access the “Network Status (CAN)” screen
3
Touch the UP or DOWN keys to select the
correct Node (Status “OK”), touch ENTER key
4
To switch OFF the device switch OFF the power
supply
Accessing the procedure from EPJgraph
Key Instructions
Touch simultaneously the LEFT and ENTER keys to
access the “Network Status (CAN)” screen
Touch the UP or DOWN keys to select the correct
Node (Status “OK”)
Touch ENTER key to access the main screen
Touch ON/STAND-BY key a few times to return to
the previous displays
Password
Key Instructions
Touch simultaneously the LEFT and ENTER keys to
access the “Network Status (CAN)” screen
Touch the UP or DOWN keys to select the correct
Node (Status “OK”)
Touch ENTER key to access the main screen
Touch UP or DOWN keys to see the “password”
menu
Touch ENTER key to select the menu:
the display will show “input password”
Touch ENTER key to enter the password
Touch UP or DOWN keys to set-up the password
“-19”
Touch ENTER key to conrm the password