Evco c-pro 3 OEM - Settings Menu - Networks Submenu UART1; UART1 Communication Parameters

EVCO | 06.08.2021 | AZ | 28114CP3OEE104
c-pro 3 OEM - Hardware manual
Menu “Networks” - Submenu “CAN Bus” parameters
N. Param. Def. “CAN Bus” submenu Min/max
52 Status OPERAT CAN machine status INIT = initialisation
STOPPED = stop CAN
OPERAT = operating
PRE-OP = in pre-operating mode
53 Bus
Status
PASSIVE CAN bus status OK = status OK
WARNING = attention
PASSIVE = bus in receiving mode only
BUS OFF = bus stopped
54 Cnt Rx - Number of packets received -
55 Cnt Tx - Number of packets sent -
56 Cnt Ovf - Number of overow packets -
57 Cnt
Passive
- Number of passages to the passive state -
58 Cnt Bus
Off
- Number of passages to the passive state -
59 Cnt Rx
Err
- -
60 Cnt Tx
Err
- -
61 Cnt Stuff - -
62 Cnt Form - -
63 Cnt Ack - -
64 Cnt Bit1 - -
65 Cnt Bit 0 - -
66 Cnt CRC - -
67 PDO TX1 - -
68 Force - -
Menu “Networks” - Submenu “UART1” parameters
N. Param. Def. “UART1” submenu Min/max
43 Address 1 Indirizzo MODBUS del dispositivo Signicant only if the communication protocol is of the MODBUS
slave type
44 Baudrate 9600 Baud rate of the MODBUS-type
communication
1200 = 1.200 baud
2400 = 2.400 baud
4800 = 4.800 baud
9600 = 9.600 baud
19200 = 19.200 baud
28800 = 28.800 baud
38400 = 38.400 baud
57600 = 57.600 baud
45 Parity EVEN MODBUS-type communication parity NONE = none
ODD = odd
EVEN = even
46 Stop 1 BIT Number of stop bits of the MODBUS-type
communication
1 BIT = 1 bit
2 BIT = 2 bit