Evco c-pro 3 OEM - LED Descriptions; Power Supply and Run LEDs; System Alarm and Communication LEDs

EVCO | 06.08.2021 | AZ | 22
005_c-pro3OEM_InterfacciaUtenteLED_001_0.1_AZ
RUN
CAN
L1
ON
114CP3OEE104
c-pro 3 OEM - Hardware manual
LED
LED description
Key instructions
Power supply LED
– If ON the device is powered
– If OFF the device is not powered
Run LED
– If ON the application software shall be compiled and
executed in release mode
– If ashing very slowly the application software shall be
compiled in debug mode
– If ashing slowly the application software shall be
executed in debug mode
– If ashing quickly the application software shall be
compiled, executed in debug mode and stopped at a
breakpoint
– If OFF:
– the device is not compatible with the application
software
– the device is not authorised to operate with the
Special ABL (Application Block Libraries)
System alarm LED
– If ON a system alarm has been triggered that cannot be
reset through the application software
– If ashing very slowly the external FLASH memory is
being accessed
– If ashing slowly a system alarm had been triggered
with automatic reset
– If ashing quickly a system alarm had been triggered
with manual reset
– If OFF no system alarm has been triggered
CAN CANBUS communication LED
– If ON the device is congured to communicate via
CAN CANBUS with another device, but the
communication has not been established
– If ashing slowly the CAN CANBUS communication has
been established, but is not entirely correct
– If ashing quickly the CAN CANBUS communication shall
established and be entirely correct
– If OFF no CAN CANBUS communication is in progress
Auxiliary LED
The operation of this LED can be set via the UNI-PRO 3
development environment