Everbilt EFLS15CI-HD - Pre-installation; MATERIALS REQUIRED (NOT INCLUDED)

Pre-installation
BEFO
RE YOU INSTALL THIS PUMP
WARNING: Risk of expl
osion. Do not ground to a gas supply line. The pump body may explode if used as a booster pump or other than a
lawn sprin
kling application.
CAUTION: Risk
of burns. Do not touch an operating motor. Motors are designed to operate at high temperatures. It is protected from heat
damag
e during operation by an automatic internal cutoff switch. To avoid burns when servicing the pump, allow it to cool for 20 minutes after
shut down befor
e handling.
□ The pump’s wa
ter suction inlet must not be more than 20 ft. above the water level.
□ Long runs and many fittings increase friction and reduce water flow to the pump. Locate the pump as close to the water source as
possible. Use as few elbows and fittings as possible. Ensure the suction line is straight and angles up toward the pump.
□ Ensure the well and pipe are clear of sand, dirt, and scale. Foreign matter will plug the pump and void the warranty. Use new pipe
for best results.
□ Protect the pump and all piping from freezing.
□ Freezing will split pipe, damage the pump and void the warranty. Check locally for frost protection requirements. The pump cannot
be installed below the frost line and the pump must be insulated.
□ Foot or check valves (not included) must be installed in the suction pipe to optimize pump suction.
□ Ensure all pipes and valves are clean and in good shape.
□ Ensure there are no air pockets in the suction pipe.
□ Ensure there are no leaks in the suction pipe. Use Teflon tape or other approved sealants to seal pipe joints.
□ Unions installed near the pump and well will aid in servicing. Leave room to use wrenches.
LAWN SP
RINKLING APPLICATION
This pump is designed for lawn sprinkling. When properly installed it will deli
ver adequate water and pressure from any well source.
PERFORM
ANCE DATA
SKU HP
DISTANCE O
F PUMP
ABOVE WATER
DISCHARGE PR
ESSURE （PSI）
10 20 30 40
GALLONS PER
MINUTE
092
5 ft.
60 56 51 37
10 ft.
53 50 46 32
15 ft.
47 44 41 25
20 ft.
41 38 34 22
1-1/2 2451001
MATERIAL
S REQUIRED (NOT INCLUDED)
Before using thi
s pump, ensure you have the following items:
1-1/2 in.
Suction/Discharge
pipe
Thread sealant
tape
1-1/2 in. Check valve 1-1/2 in. Elbow
1-1/2 in.
Union
1-1/2 in. Gate valve
4
1-1/2 in. Adaptor