48
2. Voltage Reduction Device (VRD): Less than 24V. This function reduc-
es the OCV to below 24V when required for safety. May make arc
starting more difcult.
3. Anti-Stick: Off or On. This function when turned on helps to ease rod
removal by reducing output when the rod sticks.
4. Electrode: Select from rod choices: E6010,E6011, E6013 and E7018
or Stainless E 3XX series. If the rod choice is not listed and you
desire to weld with it, determine whether it is cellulosic (cellulose
based flux) or not. If it is cellosic, such as 7010 or 8010, then select
E6010. If it isn’t and is iron powder or titania-based flux or a combi-
nation, select E7018.
Component Identification and Explanation
AC and DC Stick Screen Setup, Functions and Parameters
To Next Page