Evolis Pebble - Cleaning of the Print Head

Following a cleaning cycle, wait two minutes for the cleaner to
evaporate completely before using the printer again.
IMPORTANT !
The print head is a fragile component.
To avoid damaging it :

Never put the print head in contact with pointed and/or metal objects.

Avoid touching the print head surface with the fingers.

Always unplug the printer from the power supply before cleaning the print
head.
15
Cleaning of print head
Use the swabs (UltraClean Cleaning Kit Part Number: A5011).
Cleaning cycle: before inserting every new ribbon.
Switch the printer off.
Then, gently rub the
swab along the print
head for a few seconds.
Use a new swab and
press the middle of the
pipe until it clicks.
Switch the printer off.
Open the cover of the
printer and locate the
print head.
Cleaning