There is a Control Panel on the upper part of the printer with four LED’s.
Each is associated to a symbol showing the Pebble activity during printing.
The lights show:
The Control Panel LED’s are in either of the following conditions:
6
SWITCHED ON
SWITCHED OFF
FLASHING
Turned on
Data reception
(Pushbutton)
End of
ribbon
No card in the
feeder or feeder
not present
Cleaning
signal
Cover open
Indicators
The push button returns the control panel to its original state after dealing with
the following cases:
ABSENCE OF CARD or INTERNAL PRINTER PROBLEM
ERROR IN MAGNETIC ENCODING
CARD EJECTION
The push button also enables:
The printer to be set to stand-by
A test card to be printed
A cleaning cycle to be started
To Next Page
Loading...
