16
THG/TLG/TLT
5.1 Safety information for
transport
Improper transport
CAUTION
Material damage due to improper transport
Improper transport may cause transported items to fall down or
topple over. This may cause costly material damage.
Therefore:
• Proceed carefully during the unloading of the packaged items
duringdeliveryaswellasduringthetransporttoitsnaldestina-
tion. And comply with the symbols and information shown on the
packaging.
• Only remove device from packaging right before installation.
Note terms and conditions for storage for any return transport to the
manufacturer (refer to chapter ⮑ 5.6 Storage).
5.2 Transport inspection
The pillar is delivered as one unit in a box or packed on
pallets.
Immediately upon receipt, the shipment is to be checked for
completeness and transport damage.
Check scope of delivering
The scope of delivery of the pillar consists of the following:
• The complete telescopic pillar of the Telemag series
(THG, TLG, or TLT).
• Attached cable and low-voltage plug
(depending on the version with jack or DIN-8 plug).
• Accessories (optional).
Check shipment for transport damage
1. Unpack upon receipt.
2. Check connection socket for damage.
3. Check the telescopic pillar for damage, dents and
scratches.
5.0 Transport, packaging and
storage
In case of visible exterior transport damage,
proceed as follows:
1. Do not accept delivery or only with reservations.
2. Record scope of damage on the transport documents or
on the bill of delivery of the shipping company.
3. Initiate claim.
NOTE
Report any damage as soon as it has been recognized.
Damage claims may only be exercised within the carriers’ claims
periods.
5.3 Return shipment to
the manufacturer
Proceed as follows for any return shipment:
1. Uninstall the pillar if necessary (refer to chapter ⮑ 10
Dismantling and disposal).
2. Pack the pillar in its original packaging. Follow storage
conditions (refer to chapter ⮑ 5.6 Storage).
3. Send pillar to manufacturer.
5.4 Packaging
For packaging
The individual packaged pieces have been packaged appro-
priately for the expected transport conditions. Only environ-
mentally-friendly materials were used for the packaging.
The packaging is supposed to protect the individual compo-
nents from transport damage, corrosion and other damage
prior to installation. Therefore, do not destroy the packaging
and only remove the device shortly prior to installation. Keep
package for potential return shipment to the manufacturer
(refer to chapter ⮑ 5.3 Return shipment to the
manufacturer).
When you dispose of packaging material, do so in accor-
dance with the relevant legal requirements and local
regulations.
To Next Page
Loading...